The guy on the other forum had a concern that people posting solutions didn't fully grasp the problem.
On his Missile Command trakball-
While HOLDING ONE OF THE ROLLERS STATIONARY, and quickly spinning the other one, the up/down movement tracks perfectly.
Again, while HOLDING ONE OF THE ROLLERS STATIONARY, and very slowly spinning the other one, the cursor shows a small amount of left/right drift even though that axis isn't spinning.
So, the solution MAY be to replace the rollers and bearings, but I can see why he didn't jump on that answer.
Thinking back, didn't he say he had new rollers in there at one point and it still happened?
--
Oh- and if they're cracking on klov forums, they've never read rgvac through a newsreader..
Kerry
On his Missile Command trakball-
While HOLDING ONE OF THE ROLLERS STATIONARY, and quickly spinning the other one, the up/down movement tracks perfectly.
Again, while HOLDING ONE OF THE ROLLERS STATIONARY, and very slowly spinning the other one, the cursor shows a small amount of left/right drift even though that axis isn't spinning.
So, the solution MAY be to replace the rollers and bearings, but I can see why he didn't jump on that answer.
Thinking back, didn't he say he had new rollers in there at one point and it still happened?
--
Oh- and if they're cracking on klov forums, they've never read rgvac through a newsreader..
Kerry




