Time to repro width coils!. taking requests. I need a sample red tent/xm201

arcadecup

Well-known member
Joined
Oct 3, 2006
Messages
2,847
Reaction score
231
Time to repro width coils!. taking requests. I need a sample red tent/xm201

Ok time to get some widht coils reproduced.
My target price is to offer them for $10 each shipped. (bubbler :))

If anyone sends me a good or bad sample for the red tent /xm201 monitor I will send them 3 free coils when they are ready to return the favor.

Some I already have on my list:
xm201/ red tent widht coils.
hantarex polo
the common monitors.

LIST:
xm201/red tent
4600
hantarex polo
sanyo ezv? +
WG 19v1001 +
4900
motorola k700a
 
Last edited by a moderator:
What about the 4600 width coils? They aren't available are they? They're nearly impossible to remove from the metal (I know you can drill out the rivets) and I've had some just crumble. I'd buy a couple of those.
 
Motorola B/W Monitors - WG 19v1000, or 19v1001 I believe, I'll have to check my manual for the correct model number.

Those are always broken, or they are frozen and won't move.

Tom
 
LIST:
xm201/red tent
4600
hantarex polo
sanyo ezv? +
WG 19v1001 +
4900
motorola k700a

I can supply you all of these except the Polo

If you're doing the Motorola (which is badly needed), you should look into the horizontal linearity coil (L3...in line with the horizontal width coil). I see that thing toasted, a lot.

Shoot me a PM, or give me a call in the shop tomorrow (if you still have my number).


Edward
 
Motorola B/W Monitors - WG 19v1000, or 19v1001 I believe, I'll have to check my manual for the correct model number.

Those are always broken, or they are frozen and won't move.

Tom

Yeah I'd love to be able to get a hold of the b/w width coils, Motorola and Wells Gardner.

I think the way it works is that 19v1000 is used to refer to all three revision of that monitor 19v1001 - 19v1003. There are slight changes between them but I'm pretty sure the width coil stayed the same.
 
Last edited:
This is badly needed, awesome Chad, very glad to see you taking on this project!!

Also, maybe an option to buy just the ferrite inserts? I've been able to restore a bunch of width coils by replacing the ferrite alone, would love a place to buy these and have never seen them separately.
 
The 4600 width coil is the one I was always surprised about..that no one repro'd it. Sure it would be a tiny market of arcade guys, but those just crumble. I know I'd buy several at least.
 
Back
Top Bottom