Time Solders PCB - red lines over screen.

[kcorcoran]

Trying to repair this TIme Soldiers PCB and bunch of the vias and traces are jacked on the back. I've replaced all the traced that appeared bad or ripped off.
Schematic is a little hard to read thanks to sloppy handwriting in some spots. scumolabs hooked me up with a pic of the area that was tore up and I got it booting and no more sprite ram 1 bad error but now I have these red lines over the top (or under) the graphics. everything else looks fine.

I'm guessing maybe I have a crossed connection somewhere? pics below.

 

[Scumolabs]

Just happened to be organizing boards when I saw this .

 

[kcorcoran]

Awesome thanks. I see where I w8red something wrong. Got it out of sprite ram 1 bad and reboot loop but now here's what I got.

Going over the schematic one line at a time for 3 ICs - N10, N11, N12

 

[kcorcoran]

 

[mecha]

@Scumolabs is apparently my neighbor. I had an obsession with Time Soldiers in my early formative youth. I wish you luck in your journey.

 

[Scumolabs]

 

[Onji]

I recently stitched the multi page schematics together if its helpful. I was getting tired of dealing with separate pages. Cant do much about the bad handwriting though sorry:

 

[kcorcoran]

I recently stitched the multi page schematics together if its helpful. I was getting tired of dealing with separate pages. Cant do much about the bad handwriting though sorry:

thanks. I did the same right away. lol. it's not terrible handwriting but sometimes 7 looks like 9 looks like 4 and a 3 looks like a 1.

 

[trol666]

Hey,
my schematics

I did a rescan some time ago. Not stitching needed and maybe better to read:

STACK

trol666.stackstorage.com

 

[trol666]

Feel free to upload anywhere, no problem