Timber!!!

rknucklez

Active member
Joined
Dec 4, 2007
Messages
1,817
Reaction score
19
Location
New Jersey
does anyone know how to wire a Timber pcb into a Tapper?

I have the udlr for player one and only right chop...

I have a really nice Timber marquee scan and I am gonna buy a Phoenix arcade Timber front plate so I can swap in and out of Tapper...

Real Estate is valuable
 
...

MCR boards are similar but not 100% when it comes to the controls.

You can plug in the video plug and the power.
Im pretty sure Timber manuals were never made, so you would have to figure out the pins for the controls. Might take an hour or two, but shouldnt be hard. But you might make a mess out of your wiring harnes doing this.

Jon
 
I tried just that for the entire 19 pin J4 and J6 to no avail...



onto J5


***************************

Update

pin 1 thru 6 on J5 23 pin connector control Player 2 movement and choppage.... thanks brother Jamshid

Archive this shit
 
Last edited:
J5 is the connector I need "cut down" and "tap" into


get it?


meh
 
Last edited:
Back
Top Bottom