Thinking of adding this to my Corvette Pin

They are way too small, most of them are only 5 to 7" in Overall length height.
 
They are way too small, most of them are only 5 to 7" in Overall length height.

The one I want is only 1.7 in wide. I measured where I want it to go and that's a perfect size.

Also, they can be run on 6volts from GI to a PF, I asked the manf, but no more. More then that and you will need their reg power supply to knock the volts down to 4.5v.
 
Depends on how you intend to use them I suppose. Why would you want them any larger?


I thought he was thinking about using them as a topper, my bad. Should have read into his post a little closer.
 
Back
Top Bottom