+ Thanks ArcadeJason

Positive

ArcadeTechGW

Well-known member

Donor 5 years: 2012, 2022-2025
Joined
Apr 16, 2012
Messages
25,901
Reaction score
12,999
Rating - 100%
10   0   0
I had an edge connector repair to do, and looked up ways to do it. ArcadeJason had a nice video on how to apply the copper tape, solder it down, and then tin it effectively.

Before ArcadeJason's video, I had lumpy connectors.

After: Smooth.

Thanks ArcadeJason.
 
I need to do this on my Pole Position PCB. Got a link?
I had an edge connector repair to do, and looked up ways to do it. ArcadeJason had a nice video on how to apply the copper tape, solder it down, and then tin it effectively.

Before ArcadeJason's video, I had lumpy connectors.

After: Smooth.

Thanks ArcadeJason.
 
is he soldering on his couch?

You don't?

SW chair was in Fred's room, woulda been awkward
All rookie moves. Anyone knows the best place to solder is when you are in the bathroom, sitting on the toilet! Turn the fan on, and it will remove fumes without causing too much cooling or negative pressure. And good chances the vanity/sink is close by incase you slip and burn a finger. Can run cold water on it!
 
Is this the "look at the shiny object" thread to divert from the litigation thread?

How democratic.
No.

This is a Feedback forum.

I used the video to gain new knowledge.

The video was effective.

I left positive feedback.

There is no ulterior motive.
 
Back
Top Bottom