Testing unit supply ideas ???

whip

Member

Donor 2013
Joined
Feb 18, 2013
Messages
528
Reaction score
11
Location
pittsburgh, Pennsylvania
I am mostly a EM restorer and wondered if there is a easy something to set up to check motors or lights etc. once I remove from machine, I slide the bottom target units etc. and want a way to just touch? the jones plug to get a certain motor to run or light bank to light so I can be sure its up and running etc. without putting it back in machine each time??? will a battery set up and touch to a certain jones plug light the lights ? im sure I need a more powerful setup to check target motors???? thanks for any ideas if there is a "easy" way????
 
Why overcomplicate

The machine already has all the proper voltage ect. As long as all the outputs meter correctly. All you need are some long alligator wires. No need for a bench rig. A Jones plug male rig could also be made. This would allow you to plug in to the female Jones sites independent thereby isolating game functions. I can only see a bench rig good for testing surplus part ect.
 
ok now that sounds good but the games are in garage and the bench i work on target units motors etc. is in basement, can i run a lets say, 25 ft. wire with a alligator clip etc. and have it work as if connected in game???? or do i lose some power with long run???
 
Back
Top Bottom