FS Parts: Tested Pokeys from pulled from BallBlazer Carts

scott451

Active member

Donor 2015
Joined
Nov 23, 2014
Messages
333
Reaction score
83
Location
California
Rating - 100%
10   0   0
Minimum of 4 . + USPS shipping and paypal fees.

Two versions:

$50 each for untested BallBlazer cart as pictured below..
$55 each for hot-air de-soldered and tested pokey IC. These are fully tested using Shupac's pokey tester.

Minimum of 4. Plus USPS shipping and paypal fees.
 

Attachments

  • IMG_8769.jpg
    IMG_8769.jpg
    189.8 KB · Views: 129
Last edited:
Can you provide some more info on Shupac's pokey tester? I never heard of this.


img_1030-small-jpg.459225
 
@scott451 has the only POKEY tester I ever allowed out of my workshop. I was never satisfied with the firmware, which sometimes reports false positives (i.e. working chips test as bad). So if Scott's tester says they're good, they're almost certainly good.)

I still have the parts to build a few units. Might finish the firmware and do that if people are interested.

Of course I'd have to test it on a working POKEY, and I'm not sure I have any. All my originals may be dead at this point.
 
@scott451 has the only POKEY tester I ever allowed out of my workshop. I was never satisfied with the firmware, which sometimes reports false positives (i.e. working chips test as bad). So if Scott's tester says they're good, they're almost certainly good.)

I still have the parts to build a few units. Might finish the firmware and do that if people are interested.

Of course I'd have to test it on a working POKEY, and I'm not sure I have any. All my originals may be dead at this point.
I'd be interested and have some tested working Pokeys if you needed any for testing.
 
Last edited:
Back
Top Bottom