DKJimbo
Member
For sale is a Tempest Upright arcade machine. This machine was overhauled top to bottom. In my garage for easy pickup
The Good:
PCB stack serviced and repaired - plays perfect
AR2 board rebuilt
"big blue" capacitor replaced
WG K6100 Color vector monitor completely overhauled including: LV2000 mod, Bob Roberts deluxe cap kit
Extremely minimal monitor burn completely invisible behind tinted glass
New t-molding
All original artwork
No water damage
New light bulb and starter in marquee
New power switch
Cabinet is complete and all original other than items listed above
The Bad:
One side has a few gouges in the artwork at eye level
The lower rear corners are a bit chewed up from moving it over the years
The monitor on a cold start will "flutter" for about 2-3 minutes before the picture settles in. This happens every time and every time the picture is perfect and stable (for hours on end) after a cold start. I have rebuilt this monitor top to bottom and gone back to test everything and everything is within spec.
$1050 OBO
The Good:
PCB stack serviced and repaired - plays perfect
AR2 board rebuilt
"big blue" capacitor replaced
WG K6100 Color vector monitor completely overhauled including: LV2000 mod, Bob Roberts deluxe cap kit
Extremely minimal monitor burn completely invisible behind tinted glass
New t-molding
All original artwork
No water damage
New light bulb and starter in marquee
New power switch
Cabinet is complete and all original other than items listed above
The Bad:
One side has a few gouges in the artwork at eye level
The lower rear corners are a bit chewed up from moving it over the years
The monitor on a cold start will "flutter" for about 2-3 minutes before the picture settles in. This happens every time and every time the picture is perfect and stable (for hours on end) after a cold start. I have rebuilt this monitor top to bottom and gone back to test everything and everything is within spec.
$1050 OBO