Tempest Restoration Harness Molex

Zinfer

Well-known member
Joined
Apr 19, 2008
Messages
4,497
Reaction score
32
Location
Lima, Ohio
Well I got on the final leg of putting parts back in the cabinet and finally running the harness, which was supposed to be complete. But I'm missing the main power cord to the transformer. I think I can deal with that. But the greater problem is the portion of the harness which goes up into the Marquee lamp/speaker shelf.
Honestly both are Molex problems and I'm terrible at ordering the correct Molex part number. The portion I need is the Molex Female 5 pin that mates up with the main harness from the Marquee shelf.

www.zinfer.com/tempest.htm
 

Attachments

  • IMG_0148.jpg
    IMG_0148.jpg
    84 KB · Views: 15
i don't know where to search, but if you can't find it, just buy a new connector at radio shack and a pin removal tool and re-pin it...
 
Well I got on the final leg of putting parts back in the cabinet and finally running the harness, which was supposed to be complete. But I'm missing the main power cord to the transformer. I think I can deal with that. But the greater problem is the portion of the harness which goes up into the Marquee lamp/speaker shelf.
Honestly both are Molex problems and I'm terrible at ordering the correct Molex part number. The portion I need is the Molex Female 5 pin that mates up with the main harness from the Marquee shelf.

www.zinfer.com/tempest.htm

http://www.greatplainselectronics.com/search.asp?pg=1&stext=03-09-2057&sprice=&stype=&scat=


Edward
 
Sometimes the best solution is just to remove the single connector and put a new pair on that you have available. It doesn't always have to be the original connector so long as the mating pair matches properly.
 
I am correct though right? About the speaker and Marquee lamp being on that same connector. I'm pretty sure it's just that one connector feeding both the speaker and lamp for a Tempest upright.
 
Back
Top Bottom