tempest monitor image

kerri369

Active member
Joined
May 3, 2009
Messages
2,375
Reaction score
23
Location
brentwood, New York
i noticed that the image exceeds the monitor itself (width). the picure is bright and colourful and i don't see any burn, is there a way to shrink the image and does that have anything to do with the images being a little jumpy?thanks ahead of time.
 
Flip the test switch on the coin door. That will put a grid on the screen. Then adjust the pots in the X/Y section of the game PCB until you have the entire image on the screen, and all the vectors are connected...
 
The only pots you'll find on the game pcb are located in the silver square on the larger board below the connector. You just need a mirror while adjusting them. You can't mess up the board by turning the pots either direction....
 
Back
Top Bottom