Teenage Mutant Ninja Turtle button help

disqo

New member
Joined
Dec 13, 2009
Messages
11
Reaction score
0
Location
Adelaide, SA, Australia
I have just found out that my Donatello buttons are back to front.

The one that says jump is attack,

and the one that says attack is jump...

Whats caused this to happen?

Thanks
 
How long have you had it? Was it always like this and you just noticed? Unless it's something awkward besides a wiring issue...

Just disconnect the normally open (not the ground) wire from the jump and place it on attack and vice versa.
 
I purchased it last week and we just noticed it.

The other 3 are normal as marked.

Just Donatello is wrong. How do I change those wires? any guide will help.
 
Your game will have micro switches like the one linked below. Simply remove the quick disconnect from the lead marked N.O. (normally open) of the jump and place it on the N.O. of the attack. Then do it again going from attack to jump.

There's no need to change the common (ground) wire since those will all be daisy chained and linked to each other.

microswitch.jpg
 
Back
Top Bottom