eXidy
Well-known member
REWORK INSTRUCTIONS FOR ZOOKEEPER DATA BOARD
1. Cut trace between TP-5 and U17 pin 6 on the component side
2. Cut trace between U23 pin 13 and feed through hole on solder side.
3. Wire Tp-5 to U23 Pin 13.
4. Wire U17 pin 6 to U23 pin 12
(taken from Qix to Zookeeper conversion kit manual).
I might scan this and put up the pdf files later.
Jon
1. Cut trace between TP-5 and U17 pin 6 on the component side
2. Cut trace between U23 pin 13 and feed through hole on solder side.
3. Wire Tp-5 to U23 Pin 13.
4. Wire U17 pin 6 to U23 pin 12
(taken from Qix to Zookeeper conversion kit manual).
I might scan this and put up the pdf files later.
Jon
