Tech - Cheyenne Gun Wiring - No Molex

HighScoreSaves

Well-known member

Donor 7 years: 2013-2019
Joined
Mar 23, 2007
Messages
15,831
Reaction score
757
Location
Blaine, Minnesota
I am fixing up a Cheyenne (440 Exidy too!) and was removing the gun from the control panel.

We all know this control panel does not remove, and have to go through the coin door to unbolt the 4 bolts holding the gun down.

Guess what?

The gun did not have a molex connector, the wiring harness does...

The wires were just pinned and set insde the wiring harness side. They became unhooked before I could see what went where...

I have no clue what or where the 5 wires go in the 6 pin molex on the cabinet side!!

Anyone know this?

The colors on the harness are different than the 2 guns I have.
One gun has 5 wires in a 9 pin molex.
The other was no molex.

Looking though the manual does not show the wiring.
I do not want to ruin the optics in it.

Any help is appreciated!
 
Of course, the game was working ...
Courtesy of Mr. Mike Doyle.
 

Attachments

  • 2012-12-08_15-22-59_774.jpg
    2012-12-08_15-22-59_774.jpg
    92.9 KB · Views: 11
Last edited:
Hi Joe, my Exidy games are jammed up tight right now but I'll see if I have some pix of the wiring.
 
My only point of reference is the partial gun on the Exidy test bench, here's a shot of the internal Molex connector's location:

IMG_3590.jpg


The other end of that terminates in a Frankenstein'd JAMMA adapter so it's no use as a point of reference for cabinet wiring.
 
Back
Top Bottom