Taito Power Supply reset line?

ZEN

Well-known member
Joined
Jan 21, 2009
Messages
1,304
Reaction score
26
Location
Nebraska
I want to hook up a switcher to my Alpine ski, I got no 5v light on the piece of shasta original supply, so I have a new switcher in the shop, but looked at schematics and remember reading about the reset line on these games, thus not sure a standard supply will work, unless there is a trick with that "reset" white wires...I know about the AS supply adapter, but I figure I could get around that board by doing by hand. If I used a ATS PC power supply which I read about, what do I hook that reset line to?
 
Anyone got an idea on this, if I use a ATX power supply, do I hook the "reset" lines to the green lead on the ATX, thus like a "turn on" lead wire? I am in my shop with this now and its pissing me off, I hooled the supply up sans the reset wires and just got a green screen...thanks guys..
 
You are a good man, thank you, I could not find that and the sad thing is I probably saw it and went past it, thanks Joey...
 
Anyone got an idea on this, if I use a ATX power supply, do I hook the "reset" lines to the green lead on the ATX, thus like a "turn on" lead wire? I am in my shop with this now and its pissing me off, I hooled the supply up sans the reset wires and just got a green screen...thanks guys..

I've got adapters to plug an ATX supply right into the original harness w/o any hacking.
 
Back
Top Bottom