SOLD - PARTS Taito Elevator Action PCB working
- Thread starter behrmr
- Start date
Elevator Action is one of my faves. Free bump for squishing enemy agents.
Scoobysnack102
Well-known member
Do you happen to have the wiring harnesses. My cab I'm restoring is missing half the harnesses :-(
Ken makes those harnesses: https://www.goldenagearcadeparts.com/
I would say he goes by "wildfire" here, but I couldn't find him? Drop him a line on his site and he'll hook you up.
Ken is the best, he's on klov as @Wldfire
as an alternative, keep an eye on: https://quarterarcade.com/parts-wire?pagesize=150
OP
OP
Ken does not make Taito Classic harnesses I just recently asked him
OP
OP
I do not. In fact my cabinet had a hacked harness as well. If I had to start over it would be easy enough to make one and use the switching power supply adapter from Arcade Shop and just completely eliminate/bypass the filter board assembly.
Scoobysnack102
Well-known member
Hmm ok I will look into that. This is my first rebuild from scratch. I got the cab from a guy that was going to cut it up and the guy that had it before him gutted the entire cab. I felt that I had to save it from destruction 
How recent? Two weeks ago he was ready to make me a Front Line harness, and in February he advertised Taito Classic harnesses specifically. I'd send him a message.
OP
OP
In May. I was under the impression that front line and zoo keeper were different harnesses than Alpine Ski/Elevator Action but didn't really research it. I asked him specifically about Alpine Ski and he told me he had not done it and needed a loaner harness. Could be just confusion over what harness works with what board stack. I agree. Hit him up again and see.
