Taito Cabinet Cash Box Door.

thefader

New member
Joined
Jun 21, 2010
Messages
953
Reaction score
1
Location
South Dakota
I know there aren't many of these around, I saw some repro's on ebay once but they are gone.. Does anyone know where I could find one?
 
I know there aren't many of these around, I saw some repro's on ebay once but they are gone.. Does anyone know where I could find one?

there's a couple of different models/sizes - helps to include a pic of the front, and the door dimensions

ps i snapped up one recently that was on epay aus.:eek: sorry. ;)
 
if you like i can get in touch with the seller and find out where he had it done. it was a very well done repro.

you will need to specify dimensions though for the coin vault opening. and some pics too of the cab front and the coin vault opening.
 
Yep, IT was from an AU seller.. This is an original Crazy Climber Cabinet.. Do you know if they have more to sell? I couldnt find them on ebay again..
 
I need one for my crazy climber too! I've got a door that kind of fits but it's not perfect and it is just getting me by until I can find a real taito door or repro. Please check with that seller and post here!
 
If you want it you can PM me a fair offer for it and I'll let you know. I wasn't planning on selling it just in case I ran across another machine that didn't have one, but if you need one I will consider selling it.
 
I need one for my crazy climber too! I've got a door that kind of fits but it's not perfect and it is just getting me by until I can find a real taito door or repro. Please check with that seller and post here!

ok i'll check with him! :D oh, post a pic of the cab front, and the width/height of the opening so i can compare with the repro door. if i can find the emails to/from rph, i'll post the dims he sent me.

EDIT: the dimensions in mm as follows:
1. from the front: Width (outside dimensions)
- 243mm
2. from the front: Height (outside dimensions)
- 148mm
4a. from the front: height of hinge/tongue (top to bottom)
- 123mm
4b. from the front: width of hinge/tongue (top to bottom)
- 10mm
4c. from the front: depth of tongue from front face
- 11mm
4d. distance from top edge of door to top edge of tongue
- 10mm
and ditto bottom edge to tongue
- 10mm
5. From back: dist from rh edge (lock end) to 90 deg angle piece
- 10mm
6. steel thickness of door(mm), tongue, 90degree piece near lock
- 2mm
7. from the front: depth of edges of door from the front side
- 15mm
8. from the back:height and width of the 90 degree bit near the lock
- 123mm and 25mm

they are pretty close to my original, marginal diffs. sorry about the metric figures! check em and send back your figures in inches - they will make more sense in inches than mm, even for me!

then i'll email rph.
 
9 5/8 x 5 3/4 is what I'm looking for. That corresponds to 244mm x 146mm. So looks like it matches up with yours. Thanks! Hopefully if one of us doesn't get the door from dj, these repro's will be available too.
 
Yes I have 8 left that I had made, but can do more if there is interest.

Got an email form Andy tonight that there was people needing some for there machines here.

Cheers

Rich

guys - rich (see above) is the contact. he is a good communicator and quick to respond both email and shipping! over to you guys, i've done my bit....:D
 
Back
Top Bottom