T2 CAnon Target Light Question / Possible Issue

JODY

Active member
Joined
Apr 29, 2010
Messages
596
Reaction score
12
Location
Omaha, Nebraska
I've noticed my T2 do something a few times the last week that it never did before and it isn't noted on the rule sheet so thinking it is a problem and not a feature. Can anyone shed some light on this and possibly know what is wrong if it is a problem.

Normally when shooting the canon at least one target light is lit. I've seen two and even three. During Super Jackpot it moves. At least three times in the last week no lights have been lit. It happened again tonight and I waited for the canon to go all the way down and then start going back up before shooting. In each case, right after shooting, one of the lights has come on. In this last instance, I just happened to choose the correct one.

No issues are found at startup time. I've run tests several times this past week with no issues. All bulbs work and I've never seen a canon target bulb not work at any other time including attract mode, end of game, etc.

Is this normal? If not, any ideas on what it might be causing it?
 
Hope it is figured out...

Since I thought the last time it happened it was the next to bottom bulb I pulled it and replaced it. Upon turning the machine back on the bottom bulb did not light in attract mode. Turned it just a bit and it lit up. Played several games and always had one to three lights during canon shots. I'll have to keep an eye on it but maybe it was the bottom bulb not always lighting up and it just happened to occur a couple of times during canon shots. These bulbs go into plastic pieces that then get inserted from below so there are two sets of possible bad connections. Just odd that it would light up all the time except during a few canon shots during hours of play over a week's time.
 
It could be the black plastic socket that the bulb goes into or the header pins on the light board. Order a few of those plastic sockets and replace it, and resolder the header pins on the light board.

Should solve all of your issues.
 
Back
Top Bottom