Swords of Fury LH Kickback part# needed

tomdotcom

Active member
Joined
Nov 6, 2008
Messages
1,995
Reaction score
7
Location
Kamloops, British Columbia, Canada
Can't seem to find the part number for the lefthand outlane plunger/
nylon tip for the outlane kickback on my Swords of Fury. Any ideas? Don't see
it in the manual, if it's in there, it's hiding good :)
 
Must be generic, I see this one it should work I'm thinking...

Plunger for Kickback, Knocker, Auto Ball-Launcher: $11.95 ea

Part # A-6306-2
Standard metal ball plunger with nylon tip for use in kickback lanes, ball-launch (shooter) lanes on games with auto-plunger, replay knocker assemblies, and some other playfield devices. For use in most makes/models. This plunger measures 3-7/16 inches (87mm) overall length. Nylon tip protrudes 1/4 inch (6mm) from metal plunger. Use with coil spring # 266-5020-00 (below).

Can be used in auto ball-launch mechanisms on such games as Medieval Madness, Attack From Mars, Lethal Weapon 3, Guns 'n Roses, Terminator 2 and many others.

Replaces Data East/Sega/Stern part #'s 515-5000-00, 515-5000-01, 515-5000-02, 500-5080-00, 500-5081-00, 500-5477-00 and possible others. Replaces Bally/Williams # A-6306-2, Bally # A-550-4, and similar units.
 
Bingo! Terry @ Pinballlife sells it, he even has Swords of Fury listed as one of the games it works for. Damn, that was too easy, not sure why I didn't see it before.

Thanks anyways haha
 
I had enough fun fixing my own FishTales, did alot of work to it to get it to 100 percent. If you have any questions fire away on the forum and maybe I can help, maybe not ;) I'm not a tech expert by any means, but I have done ALOT of work to my pins so I do know a few tips and tricks and have lots of hands on experience. ALL my pins are basically at 100 percent, it's a great feeling when they're all working, which isn't always the case hahah
 
Back
Top Bottom