Switch DK Jr Cocktail to DK Remix

WrestleCrapRD

Active member

Donor 2014
Joined
Aug 23, 2014
Messages
389
Reaction score
58
Location
Indiana
Looking to change my DK Jr cocktail into a DK Remix. Does anyone know if a two board PCB will work in this? There was some question if it would or not...
 
pretty sure the d2k kit is only meant for DK board sets, but I'm sure the creators could answer with the absolute truth... I know if you run double DK (on Jr boards) the sounds on DK aren't right due to Jr hardware
 
Looking to change my DK Jr cocktail into a DK Remix. Does anyone know if a two board PCB will work in this? There was some question if it would or not...
Yes, a Donkey Kong TKG4 boardset will fit in a DKJr table. You will need to borrow the rainbow cable for the DK board, as the table runs off the edge connector.
 
IIRC, a 2 board stack does not fit in a DK cocktail that originally had the 4 board stack. Is this correct?

I see the OP stated it was going in a DKjr cocktail...this is a little off subject, but, would help clarify on a similar question that was asked. ;)
 
Right, a TKG4 board set (2 board stack) will not fit in a DK cocktail, period, and neither will a DKJr pcb. :)

If he had a 4 board TKG/2/3 stack, he could install the kit on his existing boardset, if the CPU was socketed.

IIRC, a 2 board stack does not fit in a DK cocktail that originally had the 4 board stack. Is this correct?

I see the OP stated it was going in a DKjr cocktail...this is a little off subject, but, would help clarify on a similar question that was asked. ;)
 
Back
Top Bottom