Stupid K7000 Question

Ghostnuke

Well-known member
Joined
Jul 3, 2010
Messages
4,168
Reaction score
399
Location
Lawrence, Kansas
I'm trying to wire a cabinet for use with a Neo Geo MV-1 and a 25K7000. According to the Neo pinout, the board uses composite sync.

In looking at the schematic for the monitor, I'm not sure how to wire the plug or where to even put it. I understand how/where to put the RGB pins, but not the composite sync pin. I am assuming it needs to go somewhere on that header at the left side of the schematic below, near the RGB pins.

schematic
 
I believe it would be considered pin 10 on the K7000, no? It has a straight-line 10-pin connector with pin 7 removed (as a key)....
 
I believe it would be considered pin 10 on the K7000, no? It has a straight-line 10-pin connector with pin 7 removed (as a key)....


The schematic he linked to shows it as two different "plugs". P1 is the 6 position connector while P2 is the three position. I agree that looking at it on the chassis it appears to be one connector...
 
Back
Top Bottom