Star Wars WG 6100 - display problem - bottom of display warped
Ok the display has mostly new caps in it. I didn't replace the two 7400 uF caps because I couldn't find them locally. Would that cause this? Or is it likely something else? I was hoping to fix this today so the guy can take it with him when he heads out of town tomorrow.
This crude drawing is what the base of the trench looks like normally on top and what mine looks like on the bottom.
If I move the display up about an inch and a half it straightens out and looks good but then I can't see the top of the screen and I end up with a big gap on the bottom. If I move it back down then everything curves out like shown.
Do I need to step up my looking for those two 7400 caps? Or is it likely a transistor issue? Or something else?
Ok the display has mostly new caps in it. I didn't replace the two 7400 uF caps because I couldn't find them locally. Would that cause this? Or is it likely something else? I was hoping to fix this today so the guy can take it with him when he heads out of town tomorrow.
This crude drawing is what the base of the trench looks like normally on top and what mine looks like on the bottom.
If I move the display up about an inch and a half it straightens out and looks good but then I can't see the top of the screen and I end up with a big gap on the bottom. If I move it back down then everything curves out like shown.
Do I need to step up my looking for those two 7400 caps? Or is it likely a transistor issue? Or something else?
