Star Trek Electrohome G08 screwy picture

Splurge

New member
Joined
Oct 26, 2008
Messages
2
Reaction score
0
Location
Texas
Been working on restoring a cockpit ST cab, however the monitor seems to be having an issue I havent seen addressed in any repair tips. Shot some video of it tonight.

http://www.youtube.com/watch?v=DkY0kgTUJHc

Has this strange wavy ghosting effect over the screen, with a lot of flicker. I havent really gotten into the guts of the monitor yet, mainly because I'm not sure where to start on this one. Not really familiar with repair on the G08 monitor, so I'm hoping someone here may have had a similar problem.

Thanks all!
 
It looks like your HV shutdown is wavering on the edge of kicking in.

You may be able to tweak one of those three pots on the HV unit to stabilize it a bit. A little bit the wrong way and it will shut down. A little bit the other way and it should remove the flickering.
If it shuts down, you may have to power cycle it to get it back up (after backing off on the pot a little).

Good luck-
 
It looks like your HV shutdown is wavering on the edge of kicking in.

You may be able to tweak one of those three pots on the HV unit to stabilize it a bit. A little bit the wrong way and it will shut down. A little bit the other way and it should remove the flickering.
If it shuts down, you may have to power cycle it to get it back up (after backing off on the pot a little).

Good luck-

You the MAN, man. Worked perfectly. Now I need to see about getting the geometry lined up properly. Thanks again!
 
Back
Top Bottom