Spy Hunter Side Art Question

Anthony605

Well-known member
Joined
Nov 13, 2013
Messages
1,299
Reaction score
466
Location
HOWELL, New Jersey
I am about to apply new side art on my Spy Hunter upright. The art from Phoenix (which looks amazing) has extra black on the edges that needs to be trimmed. I should have taken some quick measurements before I stripped the cabinet. Anyway, if anyone can give me a hand it would be appreciated. Can someone tell me the approximate width of the black border in the attached pic where the two red arrows are. I know it probably varies from machine to machine. I just want to know a good starting point. Thank you!!
 

Attachments

  • IMG_1179.jpg
    IMG_1179.jpg
    565.9 KB · Views: 12
It is my opinion that it varies as well. From my experience, the factory didn't seem to care. My machine has some of the black showing on the Left side, but it's non existent on the right top (original art from manufacturer). Here are some measurements from my machine. I would say just use your judgement and show a little. Whatever looks good to you.
Here is a link to 2 videos of my machine showing the trim you speak of. I'll keep the vids up for a couple of weeks. DL them if you'd like to keep for longer.

 

Attachments

  • shLeftBot.jpg
    shLeftBot.jpg
    442.2 KB · Views: 6
  • shLeftTop.jpg
    shLeftTop.jpg
    422.8 KB · Views: 6
  • shRightBot.jpg
    shRightBot.jpg
    285.7 KB · Views: 6
  • shRightTop.jpg
    shRightTop.jpg
    263.9 KB · Views: 6
Thanks! I will download them. Yeah, it looks like you are right. The factory did not give a crap! I found some Spy Hunter pics from EBAY and other sites. That line is all over the place. I will DL the videos now.
 
Back
Top Bottom