Speaker stopped working after general cleanup

bagman1

New member
Joined
Dec 14, 2009
Messages
19
Reaction score
0
Location
bumblefuck, Wisconsin
I just got a Bagman machine, and it had been sitting a long time without use. It fired up and was working properly untill I took it apart to clean it up... I got a can of compressed air; pulled the board holding the power supply and PCB out, and blew out the video card/monitor area. Upon putting everything back together, I had no sound. I verified all of the connections, played around with the sound dial on the PCB, and the speaker visibly looks OK, but still no sound. Any thoughts?
 
I'll check again...but...

I traced the wires to where they connect and everything seems good. I've got a guy that's going to give me a couple car speakers to try, but I really suspect something else.
 
Back
Top Bottom