Upon start up the screen looks like below, then after reseating the pcb harnesses, it corrects. See pics.
But, that does not prove the harnesses is the problem because:
I turned it on another time and the problem was there. I went straight to test, all graphics read and looked ok. So I went out of test mode and the problem was gone. This turn on I did not reseat harnesses but after test mode things were normal.
Thoughts?
But, that does not prove the harnesses is the problem because:
I turned it on another time and the problem was there. I went straight to test, all graphics read and looked ok. So I went out of test mode and the problem was gone. This turn on I did not reseat harnesses but after test mode things were normal.
Thoughts?

