SOLVED: Removing wheel assembly from Ivan Stewart help needed

BivCrow

Active member
Joined
Oct 12, 2017
Messages
188
Reaction score
61
Location
HOLLAND LANDING , ONTARIO
Heya klovers,

I'm basically at this stage I see that there's a slight indentation on the top of the wheel but no clue what to do from here to get these off so I can replace the art underneath.

Any assistance or breakdown tutorials would be highly appreciated 🙏
 

Attachments

  • IMG_2258.jpeg
    IMG_2258.jpeg
    373.3 KB · Views: 16
I'd suggest going to AutoZone or O'Reilly with that, and seeing which tool would work.

I think a steering wheel puller might.

Conversely, you could build one from a steel plate or angle around 1/4" thick, drill three holes for the threaded bolts, and then tighten them up one at a time, bearing the plate on the center.

Or you could get fancy, and drill a bolt (and thread it) for the center and then tighten down the three bolts and turn the center to pull the collar up.
 
1718045028593.png

You might need different bolts, but this would work. You screw it down, and then screw the big bolt into the middle boss, which pulls the hub away.

Make sure you get washers for the bolts so they don't gall the tool.
 
That's a good way if you aren't worried about reattaching it later. A wheel puller / bearing puller / whatever they are called help to eliminate deforming metal around threads.
 
Back
Top Bottom