Hey, all, I'm struggling to get a picture out of this monitor, here's the full story:
Working when purchased, when I got it home, the picture flickered/faded away shortly after running it for the first time.
Everything I've Tested and Tried:
Recapped
Re-flowed EVERYTHING
Inspected for broken traces.
Checked tube with BK 467, guns were slightly weak, did a clean and balance and the picture came back for a bit, but faded away again.
Checked Hot & V-reg out of Circuit
HV is good.
Inspected again today, found that the neck board was cracked, repaired traces.
Made sure the heater was not open.
Still no Picture, I'm stumped! Adjusting brightness / screen does nothing
Any thoughts?
I think the tube is the issue, heater might've gotten damaged somehow.