Museum of the Game® & International Arcade Museum® Forums

Working on a k7500 that would not power up. Got it working after replacing the (U101) UC3942. Replaced caps (few caps were bad) and Flyback. Replaced the B+ Pot

It powers up, but on the initial power the B+ goes to 165 VDC with no picture and no shutdown mode. I turn the monitor off. Turn it back on and the B+ is 117VDC (right on the money) and have picture, but the picture isn't the brightest and is has a slight jump to it. This pattern of B+ too high, turn off, turn on, and B+ at 117VDC is pretty consistent.

Wondering if there's a component(s) in the feedback circuit that's a bit out of spec causing it.
Back
Top Bottom