So, I'm relatively new to the Polo world. I was part of the MTC 9110 crowd, and I loved that chassis. Anyway, I have a newly rebuilt Polo 25-in. All the basics have been done: caps, FB, solder, etc. The sync is good, and I can adjust all the colors, contrast, brightness, etc., but some colors still look off. Some look neon, while other areas, like faces, have dark spots. I cannot adjust it out.
The voltage to the board is about 93 volts. I even degaussed to see if that could do anything.
By the way, I tried three different game boards, and they all have the same issue. I believe that all the wires are where they should be, and as mentioned earlier, I can adjust all pots. However, I am at a loss as to where to look/check next. I figure a good night's rest and maybe some suggestions can help
