Sinistar Upright wire harness help

thebman80

Well-known member
Joined
May 22, 2006
Messages
7,394
Reaction score
30
Location
Wallingford, Pennsylvania
I need a little help on a few parts of the Sinistar Upright harness that connects to the CP. I need to know what these 3 wires connect to and how long they are and the type of end connector on them. So I can Splice a new piece on it to fit it.

I think they are going directly to the power supply for the CP lights.

HH5C8fS.jpg


Would also like to know the same information about this 3 prong connector with the red and black wires. How long is the wire connected to them where it goes.

Any pictures and measurements of these 2 wires would be greatly appreachieated.

Zty4rSW.jpg
 
the yellow wires are for the lights (you can see them attached to the light sockets)

the grey wire is the +5 for the optical joystick
 
Ok still need to know how long that part of the harness is to connect to the power. I believe the red and black wires are the fire buttons and bomb buttons I'm guessing they go right to the interface PCB. But a measurement of the wire length would help me make a more accurate harness.
 
Last edited:
Back
Top Bottom