Simple question on MCR power supply (Spy Hunter)

dgersic

New member
Joined
Aug 19, 2009
Messages
23
Reaction score
0
Location
DeKalb, Illinois
Fixing battery damage on an MCR power supply here and I did a dumb thing; I forgot to note which way the connector headers for J3 and J4 were oriented before removing them. These are keyed headers. I just need to know which way they go back on the board. Can somebody shoot a couple of pictures of their MCR power supply for me showing J3 and J4 without the wiring harness? I'd appreciate it.
 
they only go in one way, unless someone hacked up the molex'

Not hacked. Removed. The (new) headers are currently sitting on my workbench. The old headers are in my garbage bin. I'm staring at copper traces and cursing because I thought I had taken pictures of this before removing them and now it turns out that I didn't.
 
Not hacked. Removed. The (new) headers are currently sitting on my workbench. The old headers are in my garbage bin. I'm staring at copper traces and cursing because I thought I had taken pictures of this before removing them and now it turns out that I didn't.

ok give me 30 seconds I will go look at my spy hunter


meanwhile, 30 seconds later..............
If you are holding the power supply board vertically with the big black heatsink on the left and the battery on the lower right.

The 2- 15 pin molex sit with 2 bent spots up and 1 down in the center.
Male on the left female on the right.
 
Last edited:
Back
Top Bottom