Shuffle Alley Pin Problems

Kickout

New member
Joined
Oct 15, 2016
Messages
73
Reaction score
0
Location
Bel Air, Maryland
Working on a Cherokee Shuffle Alley. The nine rear rollover switches will not activate the 1st and 2nd ball relays like it is suppose too. I've checked continuity from the switches under the playfield to the Rear Roll Over Relay. Everything is good to this point. This relay should trip the 1st and 2nd relays. The Rear Roll Over Relay will trip when tested with a nine volt battery. So I am thinking it has to be something other than the relay. Any ideas of what other switches or relays I should be looking at?
 
Game over Switch?

I had a similar problem with my shuffle alley. It turned out to be a switch needed to be adjusted on the game over stack so that it was normally closed during gameplay. Pins would retract but it would not fire the shot relays until I adjusted that switch.
 
Back
Top Bottom