Sharp Red Tent monitors - anyone cap em?

I would assume you have XM-1801 which from what I've read pretty much the same thing as my XM-200's just smaller. I've capped 2 of them and it's a breeze. Of course, I'm having some issues with 1 of them. The other looks great.

I thought the chassis were bit harder to remove than the other monitors I've worked on. I'm pretty new at this so I have limited experience. If I can do it, anyone can.
 
Last edited:
I would assume you have XM-1801 which from what I've read pretty much the same thing as my XM-200's just smaller. I've capped 2 of them and it's a breeze. Of course, I'm having some issues with 1 of them. The other looks great.

I thought the chassis were bit harder to remove than the other monitors I've worked on. I'm pretty new at this so I have limited experience. If I can do it, anyone can.

Yeah, I've only done the EZ-20 so I'm a noob meself.
 
I think the hardest part is getting the flyback cover off. Kinda pissed me off with that plastic shit attached to it. Let's just say, I don't have to worry about that anymore :)

After you do a few times it's pretty much routine. I pulled mine, replaced the flyback and put it back in about 15 minutes today.

I made sure the dag wire was attached this time.....
 
Back
Top Bottom