school me on konami connectors 3P/4P

darkcat1

Well-known member
Joined
Dec 19, 2011
Messages
4,102
Reaction score
49
Location
Winston, Georgia
I've narrowed down an intermittent issue of mine where the mutant power button on the 4P stops working to the wire that goes from the button down to the pin harness.(there's a short in it somewhere) but I'm not sure how to go about replacing it. Also the wires I got from a nice KLOVer for the start buttons on pin 10 seem to come out slightly when I change boards(actually I only did this once so far but I don't want it coming loose again...like the 4p on did for abit.)

I'm not sure how to make a wire or fix them? Where can I get parts that aren't the whole harness?
 
Back
Top Bottom