Satans work on easter

cmkryzer

Member
Joined
Jan 28, 2011
Messages
214
Reaction score
5
Location
Minnesota
Seeing I have a Satans Hollow sitting a the garage from a purchess a few months back and room to work on it seeing there are no cars in the way now, I figured todays the day to try and get going. I the last month I have pulled out and reseated any chip that i could and reinstalled. An once plugged in i get the screen shown. So does any one have any ideas where to test or things to replace. So i was hoping someone else would have had some same issues where there game.
Thanks in advanceforany ideas
 

Attachments

  • satan10.jpg
    satan10.jpg
    56.5 KB · Views: 34
I guess I'll be the first to say it... but have you replaced the interconnect cables?

If you have and all of those are good and metering good, then check the voltages to make sure the power supply is playing nice under load, then I'd swap out the CPUs, then RAM, then I'd start pulling the EPROMs and checking them to make sure they're good (mainly the program ROMs http://www.solvalou.com/subpage/arcade_roms/S/shollow). ... after that, I'd send CdJump (on the forums here) a line and see when he can take them in for repairs. ;)
 
I guess I'll be the first to say it... but have you replaced the interconnect cables?

If you have and all of those are good and metering good, then check the voltages to make sure the power supply is playing nice under load, then I'd swap out the CPUs, then RAM, then I'd start pulling the EPROMs and checking them to make sure they're good (mainly the program ROMs http://www.solvalou.com/subpage/arcade_roms/S/shollow). ... after that, I'd send CdJump (on the forums here) a line and see when he can take them in for repairs. ;)

I was thinkingalso of those pesky interconnect cables..i will get a set ordered and see what happens then...
 
Back
Top Bottom