Sanyo Wont Power Up Now...

thefader

New member
Joined
Jun 21, 2010
Messages
953
Reaction score
1
Location
South Dakota
So, I had both of my Sanyo's SOMEWHAT going, and I got my volt meter out hooked one end up to the BJ test point, the other to the chassis.. Turned it on, nothing. I took the leads off, still nothing. The fuses dont look blow, and I didnt hear anything. What did I do, and can I fix it? *sigh....*
 
If you have no power to the monitor, check the fuse down by the power supply. Verify that you have 100vac at the outlet in the bottom of the cab with your meter.
 
The power is fine in the cab, I have 3 monitors, the one that I tried checking the B+ just stopped turning on after I checked it with my new Meter. MAkes me not so sure I know how to run a meter. If it was the fuse what size do I get for replacements?


After turning it off, I hooked up the red lead to the BJ spot, and clamped the black to the chassis, powered it up, and nothing. So I assume I shorted it out somehow..
 
Pull the 2 fuses off the chassis and check them with the continuity check feature of your meter. If they are bad you could use the fuses off one of your other monitors until you get more. The only way I think you could have shorted is if 1 of your leads touched the BJ and something else at the same time. - Barry
 
With my volt meter? Which setting do I use? This thing has like 15, and ive never used a volt meter.
 
Back
Top Bottom