sanyo with warped pitcure

Buffett

Well-known member

Donor 2012-2013
Joined
Mar 12, 2010
Messages
10,991
Reaction score
263
Location
Manassas va, Virginia
ok i know i am a gulluton for punishment but new sanyo chassis unknown working condition. so i started with a new B+ pot new caps new filter cap caped audio as well. turned it on and got the image below adjusted B+ to 108 adjusted both h and v holds adjusted the v hold to get the picture where it is now and the pot is maxed out to get the image to where it is now looked at the flow chart again and dident see a specific box to fit my problem other than caps but i looked at all the caps and theyre correct so is there somthing else that i can check i will pull the chassis and look over my work to try and find any thing wrong any guidence will be apreciated again i am in the sanyo mood for some reason dont know why :)

Peace
Buffett
 

Attachments

  • DSC05058.jpg
    DSC05058.jpg
    96.6 KB · Views: 40
Something in the sync section, which is a small section. Just resolder the connector, and then trace back from that connector to everything the traces touch. Resolder as you go along and see if anything looks screwy.
 
still stumped

ok checked all my work all caps are verrifeyed correct and polarity is correct so i reflowed every thing around the connector where the video comes in within about an inch and a half of the connector. now i can get the pots to adjust a little better but the image is still squed so i am stll missing somthing any way you can take and circle the section in the pic i posted so i can look at what you are excatly refering to i am still new to the different sections of the sanyo as to the extent to what i have done is capkits and a few transistor and pot replacements it would be neat to have all the sections circled in the pic so i can have a visual reference to go by thanks for the help. one pic is with the flash and one is wthout use witchever is eayser to see thanks.

Peace
Buffett
 

Attachments

  • DSC05059.jpg
    DSC05059.jpg
    101.2 KB · Views: 13
  • DSC05060.jpg
    DSC05060.jpg
    94.3 KB · Views: 11
from bad to worse

well some more tinkering and i have gone from bad to worse what did i screw up now:eek:
 

Attachments

  • DSC05061.jpg
    DSC05061.jpg
    101.1 KB · Views: 8
  • DSC05062.jpg
    DSC05062.jpg
    89.3 KB · Views: 9
i have adjusted all pots every time the first pics are befor i reflowed and the last pics are after the reflow of all suspect parts and it got worse the pot is adjusted to get it looking that good and its worse now please dorkert could you put a circle around the sync section of the sanyo chassie so i can check that whole aera use my pic if you need to thanks ill probally have more questions on other sanyo chassis that i am trying to get working thanks for the flow chart and all the advice you have given everybody :)

ill go over my work again to see if i solderd somthing togather by mistake i am using parts boards for reference in the traces and connected pads ect

Peace
Buffett
 
finally FIXED!!!

just wanted to update this is finally fixed!! took a wile but its alive again.

it was a broken trace from D452 and R453 and a new H-Hold pot and it came back to life.

Peace
Buffett
 
Back
Top Bottom