Sanyo Upside down picture

thefader

New member
Joined
Jun 21, 2010
Messages
953
Reaction score
1
Location
South Dakota
I read the last post about Sanyos displaying upside when DK are installed onto DK Jr. Monitors?


I hooked this up to my new DK board, and the picture was upside down. If I get a DK Jr board, will it display as right side up??
 
Dip switch on the PCB board? I have 3 monitors, and only this one displays upside down.
 
I tried it with it flipped both ways. It was the same. I have 3 monitors, and only this specific monitor displays upside down.. So Ill have to try to switch the yoke wire.s
 
Where is the best place to cut these wires and switch them?? on a sanyo?? Does anyone have a picture?? I looked at the bobroberts diagram, but I can figure it out on my Sanyo.
 
Check to see if the yoke connector has already been "split".
If it has, then you will only need to unplug and flip one half of the connector and plug it back in. (the Green and Yellow pair of wires are your Vertical)

WARNING - Do not ever mix the pairs of wires.
Red and Blue only go to the two pins they are currently on. Green and Yellow only go to the two pins they are currently on.
You can swap where Green and Yellow are, or swap Red and Blue around, but never something like where Green and Red are.
(make any sense?)
 

Attachments

  • Sanyo Yoke Flip.jpg
    Sanyo Yoke Flip.jpg
    91.8 KB · Views: 26
Back
Top Bottom