Sanyo Horizontal Hold

Fudd

Active member
Joined
Jun 5, 2006
Messages
2,382
Reaction score
13
Location
Kalamazoo, Michigan
recapped a sanyo 20ez and i was still getting some foldover so i replaced c202 and c454 caps which were not in the original cap kit i got....now i can't lock down the horizontal hold which i could before i replaced the 2 caps.....c201 is also correct at 10uf 250v...didn't have 50v on hand....only caps not replaced are the 2 np's and the filter..

b+ is 108v..
 
Last edited:
yup the bipolars are a big part of a cap kit on most all monitors.

why people that sell kits are to lazy to include them is just stupid.

i sell complete kits as long as i have a complete list.

if you need any caps for the sanyo i stock all of them in HQ 105deg and just a couple HQ 85deg.

Peace
Buffett
 
Am about too work on my donkey kong and cap it am new too this any suggestions.


yes

go slow and get all the caps in the rite place.
watch for solder bridges to the other pads. they are close on this chassis and it happens often.

do you have a complete kit or do you need one.

also change out the B+ pot the old ones are a POS.

re-flow the chassis and neck board wile you have it out.

Peace
Buffett
 
dont break the board, dont break the board, and for sure dont break the board.
 
cool glad it was an easy fix.:)

why people that sell kits do not include those BP caps is beyond me they are not expensive. some are but not those.

i sell complete kits for the Sanyo that include the B+ pot and filter cap.

Peace
Buffett
 
Back
Top Bottom