Sanyo EZ20

BJWalker1371

Member
Joined
Jun 25, 2009
Messages
179
Reaction score
0
Location
Dandridge, Tennessee
Ok... Heres the situation, I recently installed a much needed cap kit on the Sanyo in my Popeye. The cap kit install went smoothly and I inspected and everything looked fine upon power-up but the screen slowly crept down to the resulting picture below. Pulled the chassis and checked the caps reflowing solder and all are oriented correctly and look fine. No bad traces that I could find. Checked every one of the pots, All were ok. B+ is dialed into 108. Can anyone point me in the right direction on how I may fix this? It is always fullscreen upon power up but creeps down to the included picture after a few minutes.
 

Attachments

  • Picture 449.jpg
    Picture 449.jpg
    103.5 KB · Views: 18
Back
Top Bottom