Sanyo Ez20 B+ filter cap, what and where?

470uF 160V snap cap, location on chassis is C606 (next to the heat sink) and yes Bob carries them, they are listed under filter caps.

cool beans
Found this bad boy on bobs site it should do the trick
470uf200v B+ filter
Thanks for letting me know which one on the chassis to try.

I am going to grab one of these too
from bob "LA5112N Sanyo 20EZ Regulator" where are these located on the PCB and are there more then one voltage regulators?
 
Last edited:
That is IC601 its a 9-pin SIP. If I remember correctly, if your looking at the monitor from the back its on the left corner closest to you.
 
That is IC601 its a 9-pin SIP. If I remember correctly, if your looking at the monitor from the back its on the left corner closest to you.

Cool thanks for the heads up gregatron. Is the 9-pin SIP you speak of the LA5112N listed on Bob's site? This will sound scrubby but does this monitor just have the 1 voltage regulator?

I am giving this monitor the works trying to get it back up and want to order all the parts.

done to date
full cap kit for monitor and audio
HOT
flyback

not much left to do
B+ filter
voltage regulator(s)
 
Yes, IC601 is an LA5112N and it is the only voltage regulator.
FYI, the only thing I would add to your list if you're going all out is pots.
The B+ adjust, the H-hold and the other 5 on the remote board. That is really only if
you feel it's necessary of coarse. These pots have been known to become flakey,
Bob also sells them.
 
Yes, IC601 is an LA5112N and it is the only voltage regulator.
FYI, the only thing I would add to your list if you're going all out is pots.
The B+ adjust, the H-hold and the other 5 on the remote board. That is really only if
you feel it's necessary of coarse. These pots have been known to become flakey,
Bob also sells them.
Well if i am going this far why not, Pots will be added to the list as well.
 
Back
Top Bottom