sanyo chassis where does this go ?

djdaveofkc

Active member
Joined
Aug 9, 2008
Messages
1,091
Reaction score
12
Location
Gardner, Kansas
Hello guys, i've noticed i have a couple different sanyo chassis's and I have 2 that have a extra wire that my other one does not. It is the red wire that connects to the chassis where the other board does not have this. Where does this plug into? thanks. It is the white plug in the middle of the pic and it is attached to the board next to the #'s D214 & R232
 

Attachments

  • 100_2687.jpg
    100_2687.jpg
    95.5 KB · Views: 46
That would be the wire that supplies the juice to your inverter board. If you don't have an invertr sitting on top of your flyback cage then you can either cut the wire off or coil it up and tuck it in the chassis. Tape up the white end of it before you tuck it in though.
 
Back
Top Bottom