Sanyo 20EZV Issue at C406

scubaesq13

Active member
Joined
Nov 29, 2018
Messages
210
Reaction score
27
Location
New York, New York
I have a Sanyo 20EZV with a burnt solder pad at the negative leg of C406. What is the best way to jumper the negative leg? Do I have to jumper anything else?

I'm a bit rusty on reading schematics, but if I'm reading it right the negative leg at C406 just goes to ground.
 
Yes it goes right to ground. I usually take a fiberglass pen, or a mini grinding pin, clean up the solder pad and part of the trace and just blob the solder on the leg and the trace/pad.

Take a pic of the joint you are trying to fix and we can offer help with some of the best practices to fix that.
 
Back
Top Bottom