wxforecaster
Member
Well, I finally figured out how to remove my Sanyo 20EZ monitor from m DK Jr for a cap kit. Amazing how the "duh" moment hit on how to get it out. Anyways...
Before removing the monitor, I noticed this. Beginning to wonder if that's the cause of my problems.
There's a red wire that extends from 0214 - R232 on the chassis board to a 3 pin connector that wasn't connected to anything.
Where is this supposed to go?
Before removing the monitor, I noticed this. Beginning to wonder if that's the cause of my problems.
There's a red wire that extends from 0214 - R232 on the chassis board to a 3 pin connector that wasn't connected to anything.
Where is this supposed to go?