Sanyo 20ez B+ tolerance

Hothman

Active member

Donor 2012
Joined
Oct 31, 2011
Messages
646
Reaction score
26
Location
Coastal, Georgia
What's the tolerance on a Sanyo 20ez on the B+?

I'm reading 109.6v. I don't want to mess with the pot if that is close enough. I am getting a blinking on the monitor about every 5 minutes, but I'm not sure if it's related to the B+. Thanks.
 
That's plenty close enough. Most monitors are plus or minus 10%....some even 20%. The Sanyo monitor doesn't state.....but one and a half volts isn't gonna hurt anything.

Edward
 
By blinking, do you mean the picture snaps, like it's collapsing then coming back really quick? On a Sanyo, that's usually because the flyback is failing, and it's arcing out of the case every once ina while. Ask SuperGWario about it, lol.
 
It could be collapsing, but it's happening so fast I almost need to take a video and see if I can slow it down. The monitor has a new cap kit and flyback. I think I remember it blinking before I swapped monitors on it. That's why I'm not sure the blinking has anything to do with the monitor. will a failing power supply do that?
 
I always stick my TV alignment tool in the pot to adjust the B+ before I power on. I try to be careful as possible when doing adjustments I don't want to get zapped. I also put alligator clip wire on the measuring spot and clip it to the positive lead on the multi meter.

I'd adjust the b+ down slightly then leave the monitor on for an hour and adjust it to 108.00. 109.00 is in range I'd say your getting some sort of other issue. Doesn't hurt to try though. Unless you get zapped! Then your gonna have a bad day.
 
Back
Top Bottom