Sanyo 20-Z2AW Issue after Cap Kit

8-Bit

Member
Joined
Sep 25, 2008
Messages
189
Reaction score
2
Location
WOOSTER, Ohio
Sanyo 20-Z2AW Issue after Cap Kit [RESOLVED]

I just finished doing a cap kit on one of my Punch-Out monitors and I've got a problem.

The biggest issue is that the top inch or so of the screen is flickering and going askew. See picture.

Where do I start on correcting this? Did I put a capacitor in backwards? I'm not sure what that would even look like.

Thanks.

[RESOLUTION]
Flyback was turned up too high, H-Hold needed adjusting (it's located in the middle of the main PCB, not where the other pots are).
 

Attachments

  • DSC08642_640x480.jpg
    DSC08642_640x480.jpg
    37.9 KB · Views: 19
Last edited:
I would start with guessing with the brightness being way to high and probably the b+ out of adjustment.
 
[RESOLUTION]
Flyback was turned up too high, H-Hold needed adjusting (it's located in the middle of the main PCB, not where the other pots are).
 
Back
Top Bottom