Road Blasters Question

FrizzleFried

Well-known member

Donor 2011
Joined
Mar 20, 2007
Messages
54,193
Reaction score
5,245
Location
NAMPA, Idaho
I picked up a Road Blasters kit from a fellow KLOVIAN and it arrived today. Both my Indiana Jones and Marble Madness kits come with flat smaller connectors that plug directly in to the System 1 motherboard whereas the connectors for the Road Blasters kit have molex type connectors (square 12-pin for the wheel and a flat 5 pin for the pedal). Is there a harness that is supposed to go between these controllers and the mainboard?

If so... anyone have one?

EDIT: Also... anyone have a link to a MANUAL for Road Blaster? CrazyKong has the schematics, but that's it.

Finally... it appears my Indiana Jones cab ISN'T set up for Road Blasters... it has 2 holes at the bottom where the pedals should be but the pedals have 4 holes... and I don't think the 2 holes that are there acually line up with any of the 4 on the pedal. Bummer.
 
Last edited:
I think I have a spare one of these. I bought two RB cabinets and converted one to Marble Madness.

I'll dig around and see if I can find it.
 
I think I have a spare one of these. I bought two RB cabinets and converted one to Marble Madness.

I'll dig around and see if I can find it.


The KLOVian who sold me the kit found it separate from where he stored the rest of the kit. He's sending it to me. I do appreciate the offer though...
 
Friz, can you post a pic of the piece you are talking about when you get it? I don't have anything plugged into my RB daughterboard; just attached to the main board. Maybe this is why it says "No Cartridge". :)
 
There isnt anything that plugs into the cartridge. the cartridge just connects to the mainboard.

I see, he was talking about the cp. Oh well, I was hoping it was easy as finding a piece I didn't have.

Thanks for clearing it up.
 
Back
Top Bottom