You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Museum of the Game® & International Arcade Museum® Forums
I'm working on an Amiga multisync (non-arcade) monitor and it has 4 badly burned carbon film resistors (at least from what I can tell they are that type). The schematic says they are 2.2KOhm, but have no wattage rating listed anywhere in the manual or schematic. The polyester film caps that are in this same circuit are listed as being rated for 250V, so I'm assuming this circuit carries a good bit of current. What wattage rating resistor should I go with?
Thanks!