Reproduction Coin Control stickers

jmduncan

Member
Joined
Oct 18, 2011
Messages
56
Reaction score
2
Location
Manchester, Pennsylvania
I have reproduced some Coin Controls S-10 selector assembly stickers for the inside of coin doors. I took upon this project when I realized there was no saving my stickers from the inside of my pole position coin doors. I have three left, since I ran out an even sheet so I would not waste material. I also reproduced the coin control inspection stickers commonly found on the doors as well. I have 13 of these left, again to not waste material. Just curious if there would be any interest in these and if there is enough interest I may do more runs. Pictures are below.
 

Attachments

  • IMG_4764.jpg
    IMG_4764.jpg
    94.2 KB · Views: 85
  • IMG_4765.jpg
    IMG_4765.jpg
    89.7 KB · Views: 47
where were the assembly stickers at on the coin doors? any pics?
 
Here are some pics of the stickers on the doors. I will have to dig up the ones I took before the restoration.
 

Attachments

  • IMG_4763.jpg
    IMG_4763.jpg
    91.7 KB · Views: 17
  • IMG_4762.jpg
    IMG_4762.jpg
    94.4 KB · Views: 20
Back
Top Bottom